6 min read

Salt-air corrosion: what actually protects a coastal air conditioner

Which parts fail first on a Bakoven installation, what genuinely slows corrosion down, and the cleaning habits that do more than any coating.

Salt is not a cosmetic problem on the coast. Once sodium chloride settles on a coil or a terminal, it holds moisture against the metal and keeps the corrosion reaction going long after the spray has dried. That is why coastal equipment fails in ways inland equipment does not, and why the cleaning routine matters more than any single product.

What fails first

Aluminium coil fins are the most exposed surface on an outdoor unit. Salt etches the fin surface, dirt sticks to it, and airflow drops. The unit still runs, so nothing looks broken, but it has to work harder and longer to move the same heat.

Next are the small steel parts: case screws, bracket bolts, fan guards, drain tray supports. These are rarely inspected and often the reason a unit cannot be opened for service three years later.

Electrical connections are the quiet failure. Salt-laden damp air corrodes terminal blocks and spade connectors on the outdoor unit, raising resistance until a compressor or fan motor fails for a reason that looks electrical but started as atmospheric.

On refrigeration equipment, door hinges, gaskets and evaporator coils in wet rooms are the usual casualties, and drain pans corrode from the inside out where condensate sits.

The routine that actually helps

Rinse the outdoor coil with low-pressure clean water on a regular schedule, more often in the months when the wind carries spray. Low pressure is important: a high-pressure washer bends fins flat, which permanently reduces airflow and traps more salt.

Keep the area around the unit clear so it can dry. A unit boxed in by stored items, plants or a solid screen stays damp far longer than one with free airflow on all sides.

Check and clean the condensate tray and drain. Standing water plus salt is the fastest route to a rusted tray and a blocked drain that eventually leaks into a ceiling.

Have electrical terminals inspected as part of a service, not as an emergency. Cleaning and re-terminating a corroded connection is inexpensive; replacing a compressor is not.

What does not help as much as people expect

Coated coils do last longer in coastal conditions, but the coating is only as good as its condition. A scratched or damaged coating corrodes at the damage point, so it still needs inspection.

Spray-on anti-corrosion products sold for marine use vary widely. Some are useful on exposed fixings and cabinet surfaces when applied correctly. Applied to a hot coil or over dirt, they can trap contaminants and make cleaning harder. Ask what is being applied and why before it goes on your equipment.

Painting over rusted brackets or trays hides the problem for a season and then makes the part harder to replace.

A realistic coastal service interval

There is no single correct interval, because exposure varies enormously between a protected courtyard in lower Bakoven and a balcony taking the full south-west weather. A unit that is visible from the sea will need attention more often than one screened by the building.

The practical approach is to inspect early, record the condition, then set the interval from what the equipment actually shows. A unit that arrives at the first service with a clean coil and sound fixings can go longer. One that arrives with salt crust and corroded screws needs a shorter cycle.

Tell us what the equipment is doing

Send the service you need, the property type and the suburb. For refrigeration, include the temperature it is holding. We will come back with the next sensible step.