5 min read

Why coastal humidity changes how your air conditioner performs

Latent load, condensation and mould risk on the Atlantic Seaboard, and why a system that is cold enough can still feel clammy.

An air conditioner does two jobs at once. It lowers the air temperature, and it removes moisture by condensing it on the indoor coil. On the Atlantic Seaboard the second job is often the bigger one, and a system sized only for temperature will struggle to keep a room comfortable in humid weather.

Sensible and latent load

Sensible load is the heat you can measure with a thermometer. Latent load is the energy tied up in water vapour, and removing it takes a cold coil and enough contact time for the moisture to condense.

A humid room can feel sticky even when the thermostat reads 22°C, because the moisture in the air slows evaporation from your skin. Running the system colder than necessary to compensate wastes energy and can overcool the room before the humidity comes down.

Where the water goes

Every litre of moisture removed has to leave through the condensate drain. On a humid day that can be a surprising volume, which is why a marginal drain fall or a partially blocked tray shows up as a leak rather than a cooling complaint.

Coastal drains also grow biological film faster in warm, wet conditions. A drain that worked last summer can be restricted by the next one. If water appears at the indoor unit, stop running it and have the drain cleared rather than catching it in a bucket.

Signs the system is not managing humidity

The room reaches setpoint quickly but still feels clammy, the unit short-cycles, or there is condensation on supply grilles and window frames. Mould smell in the air path usually means the coil, tray or duct liner has stayed wet.

An oversized system is a common cause. It blasts the room down to temperature in a few minutes, then stops, so the coil never runs long enough to wring the moisture out. Correct sizing and a fan speed that allows proper dehumidification matter more than headline capacity.

Practical steps

Keep filters clean so airflow stays within design. Run the system on a sensible setpoint rather than the lowest number, and give it time to work rather than cycling it on and off. Where the building allows, ventilate when the outside air is drier rather than during a humid spell.

Have the drain, tray and indoor coil inspected as part of servicing. On a coastal property, a dry tray and a clear drain are as important as a clean filter.

Tell us what the equipment is doing

Send the service you need, the property type and the suburb. For refrigeration, include the temperature it is holding. We will come back with the next sensible step.