6 min read

Heat pump performance through a Cape winter

How defrost cycles, air temperature and backup elements decide whether your hot water keeps up in cold, damp weather.

A heat pump does not make heat, it moves it. That is why it is efficient, and also why its output changes with the air around it. Cape winters are mild by international standards but damp and often around 8 to 12°C at night, which is exactly the range where defrost behaviour and correct sizing start to matter.

Cold air, lower output

As outdoor air temperature falls, the temperature difference the unit has to work across increases, so capacity and efficiency both drop. A unit that heats a cylinder quickly in March takes longer in July.

This is not a fault. It is a sizing question. A heat pump matched to summer performance alone will feel marginal in winter, particularly in a household with high hot water demand or a large cylinder.

What defrost is doing

The outdoor coil runs colder than the air to absorb heat, so moisture in the air freezes on it. The unit periodically reverses to melt that frost, which temporarily stops heating water and produces water or steam at the outdoor unit.

Some frost and the occasional defrost cycle are normal. A unit that stays iced up, defrosts constantly, or leaves a solid block of ice at the base has a fault: a sensor, airflow problem, blocked drain or refrigerant issue.

The backup element

Most installations include an electric element in the cylinder as a backup. It should be a fallback for cold snaps and high demand, not the primary heat source all winter. If the element is running most days, either the heat pump is undersized, the cylinder is losing heat, or the unit is not performing.

Check the controller's element hours if it records them. A sudden increase usually corresponds to a fault rather than weather alone.

Installation details that decide performance

Airflow around the outdoor unit is critical. A unit crammed into a service recess, behind a solid screen or next to a wall recirculates its own cold air and defrosts badly.

Condensate must drain away from the base. If it pools and refreezes, ice builds up around the coil and the unit spends longer in defrost.

Insulate the hot water pipework between the unit and the cylinder, and make sure the cylinder itself is properly lagged. Losing heat after it has been paid for is the most common efficiency leak in a domestic system.

Tell us what the equipment is doing

Send the service you need, the property type and the suburb. For refrigeration, include the temperature it is holding. We will come back with the next sensible step.